pooch692000

Have a brand new set of 7.4c/5000mh floureon lipos. Set the huperion charger up for 2s, 5A charge. Connect balancer and leads and hit enter and get “balancer con. connected” then beeping and “check the batt. Low voltage. Balancer is plugged into the 2s balancer adapter. Any ideas? Help

pooch692000

Is the adapter in battery corrext for the board? Board has 5 pins and batt adapter has 3 female holes

pooch692000

Charger uses its own hyperion balancer tab. Am using floureon lipos. Moved the femal adapter from battery over so the red wires lines up and it starts charging. However inget the “open circuit message”. Maybe i ned a different adapter from charger aoits compatible with my battery?

Propworn

My Feedback: (3)

Hyperion makes different balance boards that plug into your balance lead. First you have to identify the type of balance plug the battery manufacturer has used then order the right board.

pooch692000

Thanks. I was just reading and figured it out.

Propworn

My Feedback: (3)

Good for you its all part of the learning curve. Good luck have fun.

pooch692000

Can i use a oarallel charging board in this charger?? Want to be able to charge multiple same cell batts at once

Propworn

My Feedback: (3)

I think the output is only 6 amps with that charger. I think you would need at least a charger with 10 amp output to charge two of those 5000 mah packs in one hours time. Any way there is always adaptors out there that allow parallel charging. This link might help to understand parallel charging https://sites.google.com/site/tjingu...allel-charging

pooch692000

Yes only 6 amps and 50 watts. I’d need 84 watts to charge at 10, sonwouks have toncharge at 5.95 amp instead of the 10 for 1c. Also as far as setting the mh on charger do inuse 10,000 or 5000? Not evenaure the charger can go up to 10,000

Propworn

My Feedback: (3)

I use a powerlab 8 with parallel board. I also use two server power supplies in series to give 24 volts at 47 amps.

Revolectrix

Revolectrix

Convert HP server power supply for RC use - TJinTech

I don't know how handy you are at modding the server power supplies but there are guys out there that sell them already done.