goirish

I have a seagull model that is covered in oracover and it needs to be tighten up. Wanted to make sure when I use the iron or the heat gun. I am familiar with ultra but not this name.

daveopam

My Feedback: (9)

I was told it was the same stuff.

David

Edwin

My Feedback: (2)

I've had some ultracoat in the past that had oracover printed along the backing edges.
Edwin

Top_Gunn

My Feedback: (6)

It's the same thing. I've used rolls of Ultracote that had "Oracover" printed on the paper that you peel off the sticky side.

Gray Beard

My Feedback: (-1)

Same thing, when I go to the LHS to buy covering I dive into the big box of old covering they keep in the corner and buy up any of the covering with either name.

jaka

Hi!
It's called Oracover in most countries, only in the US it's called Ultracote..beats me?