sig kadet lt-40 manual
#1
Member
Thread Starter
Join Date: Oct 2004
Location: wooster,
OH
Posts: 45
Likes: 0
Received 0 Likes
on
0 Posts
sig kadet lt-40 manual
whoever has the manual, can you please tell me what it says about required tools for the ARF version? also, what optional tools does it recommmend? thanks.
#4
Senior Member
Join Date: Nov 2006
Location: Las Vegas,
NV
Posts: 298
Likes: 0
Received 0 Likes
on
0 Posts
RE: sig kadet lt-40 manual
Sig thin and thick CA
Sig kwik set 5 min epoxy
sig kwik shot CA debonder
screwdriver assortment
pliers-needle nose and flat nose
small allen wrench assortment
pin vise for small dia. drill bits
hobby knife with sharp #11 blades
small power drill with selection of bits
dremel tool with selection of sanding and grinding bits
scissors
sandpaper
heat iron and trim seal tool
masking tape
paper towels
alcohol and/or acetone for epoxy clean up
Hope this helps.
OOPS..forgot diagonal wire cutters
Sig kwik set 5 min epoxy
sig kwik shot CA debonder
screwdriver assortment
pliers-needle nose and flat nose
small allen wrench assortment
pin vise for small dia. drill bits
hobby knife with sharp #11 blades
small power drill with selection of bits
dremel tool with selection of sanding and grinding bits
scissors
sandpaper
heat iron and trim seal tool
masking tape
paper towels
alcohol and/or acetone for epoxy clean up
Hope this helps.
OOPS..forgot diagonal wire cutters
#5
Senior Member
My Feedback: (4)
Join Date: Dec 2001
Location: Edgewood,
KY
Posts: 1,223
Likes: 0
Received 0 Likes
on
0 Posts
RE: sig kadet lt-40 manual
I have an LT40 ARF manual. Here's what's not on Snacker's list. It's all pretty much everyday items.
Pins (T-pins) to hold parts together.
90 degree triangle - to square parts, i.e. the vertical stabilizer.
Soapy Water Solution (or Sig Pure Magic Model Airplane Cleaner, Fantastic, Windex, Formula 409) - to help apply decals.
Fine-point felt-tip pen or pencil.
Ruler and/or tape measure.
Drill and 1/16", 3/32", 1/8", 5/32" drill bits.
Flat file - for removing burrs and sharp edges from wire parts.
80 or 100 grit sandpaper.
Pins (T-pins) to hold parts together.
90 degree triangle - to square parts, i.e. the vertical stabilizer.
Soapy Water Solution (or Sig Pure Magic Model Airplane Cleaner, Fantastic, Windex, Formula 409) - to help apply decals.
Fine-point felt-tip pen or pencil.
Ruler and/or tape measure.
Drill and 1/16", 3/32", 1/8", 5/32" drill bits.
Flat file - for removing burrs and sharp edges from wire parts.
80 or 100 grit sandpaper.