RCU Forums
Page 2 of 2
1
2
Show 40 post(s) from this thread on one page

RCU Forums (https://www.rcuniverse.com/forum/)
-   Beginners (https://www.rcuniverse.com/forum/beginners-85/)
-   -   Propeller Installation Question (https://www.rcuniverse.com/forum/beginners-85/11269046-propeller-installation-question.html)

albietz 10-20-2012 05:47 PM
RE: Propeller Installation Question
 
Thanks for all the responses. Regarding prop size, the comments are well taken. I know the 10" is undersized which is why I was only looking into trying the 4 blade. Max prop diameter is 11", and I had been leaning in that direction anyway. Thanks

jaka 10-21-2012 02:10 AM
RE: Propeller Installation Question
 
Hi!
Why not use a 11x8 then?

drac1 10-21-2012 02:57 AM
RE: Propeller Installation Question
 

ORIGINAL: albietz

Thanks for all the responses. Regarding prop size, the comments are well taken. I know the 10'' is undersized which is why I was only looking into trying the 4 blade. Max prop diameter is 11'', and I had been leaning in that direction anyway. Thanks
I use aluminium spacers machined to the thickness i require. These have been successful on my YS DZ16o's.

Regards
Scott

drac1 10-21-2012 02:58 AM
RE: Propeller Installation Question
 

ORIGINAL: albietz

Thanks for all the responses. Regarding prop size, the comments are well taken. I know the 10'' is undersized which is why I was only looking into trying the 4 blade. Max prop diameter is 11'', and I had been leaning in that direction anyway. Thanks
I use aluminium spacers machined to the thickness i require. These have been successful on my YS DZ16o's.

Regards
Scott

albietz 10-21-2012 07:10 AM
RE: Propeller Installation Question
 
That's one of the props that I have and intend to try.

bruce88123 10-26-2012 08:58 AM
RE: Propeller Installation Question
 
http://downloads.hobbico.com/evpl/osm/ev15610.pdf be sure the item # 10 washer is there. It is easy to lose and NOT be noticed.


All times are GMT -8. The time now is 05:45 PM.
Page 2 of 2
1
2
Show 40 post(s) from this thread on one page


Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.