robarts retract binding
#1
Junior Member
Thread Starter
Join Date: Aug 2013
Posts: 3
Likes: 0
Received 0 Likes
on
0 Posts
robarts retract binding
I am having problems getting the gear to retract. replaced with new actuator new pin and brass fitting plus new trunion. the actuator moves up approx 1/4 " and stops. are there any adjustments I should check. Could the problem be with the grove when in the gear down lock position. I did break the trunion during hard landing. AC IS THE TOP FLIGHT 86.5 SUPER MARINE SPITFIRE.
THANKS FRANK
THANKS FRANK
#3
Junior Member
Thread Starter
Join Date: Aug 2013
Posts: 3
Likes: 0
Received 0 Likes
on
0 Posts
Thanks for quick reply. upon removing the gear i found the trunion pin tight, and the pin/torx holding the bass cam roller was at the high point of the side frame. When I removed the trunion pin the actuator worked all the way, up and down.