new shaft needed 3.175 X 50 mm
#1
Thread Starter
My Feedback: (1)
Join Date: Mar 2005
Location: Branchburg,
NJ
Posts: 266
Likes: 0
Received 0 Likes
on
0 Posts
new shaft needed 3.175 X 50 mm
I need a new 3.175 X 50 mm shaft for an KDS inrunner motor. Does anyone know where I can buy one? My on line searches have been unsuccessful
Dave
Dave
#4
Junior Member
Join Date: Jun 2015
Posts: 7
Likes: 0
Received 0 Likes
on
0 Posts
http://www.rcgroups.com/forums/showthread.php?t=1630849
If you use a CD rom shaft, file a flat and put a 1/8" wheel collar in place of the c-clip and groove.
If you use a CD rom shaft, file a flat and put a 1/8" wheel collar in place of the c-clip and groove.
#5
Thread Starter
My Feedback: (1)
Join Date: Mar 2005
Location: Branchburg,
NJ
Posts: 266
Likes: 0
Received 0 Likes
on
0 Posts
Birddog
Good idea, I will have to look in may box of computer parts and see what i have . My shaft is pretty simple and only has a flat on one end. If I can't find a CD rom I may just buy a 3 ft length of precision drill rod for $3 from Mcmaster Carr.
Good idea, I will have to look in may box of computer parts and see what i have . My shaft is pretty simple and only has a flat on one end. If I can't find a CD rom I may just buy a 3 ft length of precision drill rod for $3 from Mcmaster Carr.