Brushed/Brushless motors, speed controls, gear drives Discuss all aspects of brushless motors, brushed motors, speed controls (ESC's), gear drives and propellers in this forum.

Brushless pulling out

Reply

Old 02-06-2019, 08:51 AM
  #1  
Volo
Thread Starter
 
Join Date: Dec 2014
Posts: 20
Gallery
My Gallery
Models
My Models
Ratings
My Feedback
Default Brushless pulling out

The exterior rotating element is moving forward by close to 1/4 “ when I speed up the motor. Is it normal for a brushless motor?

Last edited by Volo; 02-06-2019 at 10:16 AM.
Volo is offline  
Reply With Quote
Old 02-06-2019, 10:50 AM
  #2  
Volo
Thread Starter
 
Join Date: Dec 2014
Posts: 20
Gallery
My Gallery
Models
My Models
Ratings
My Feedback
Default

I found the answer by myself. The lock washer (E-clip) on the shaft wears out or got loose.
But I have another problem. I have 2 brushless motors with 4 mm shaft diameter. I need an E-clip and a new shaft. Cannot find mine on eBay, only 3.17 mm.
Where to buy them?




Last edited by Volo; 02-06-2019 at 04:56 PM.
Volo is offline  
Reply With Quote

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


Thread Tools
Search this Thread

Contact Us Archive Advertising Cookie Policy Privacy Statement Terms of Service