RCU Forums - Hurc 40 and Hurc 18 problems getting full throttle from motor

RCU Forums (https://www.rcuniverse.com/forum/)

- Brushed/Brushless motors, speed controls, gear drives (https://www.rcuniverse.com/forum/brushed-brushless-motors-speed-controls-gear-drives-123/)

- - Hurc 40 and Hurc 18 problems getting full throttle from motor (https://www.rcuniverse.com/forum/brushed-brushless-motors-speed-controls-gear-drives-123/11597214-hurc-40-hurc-18-problems-getting-full-throttle-motor.html)

cvint

04-06-2014 05:07 AM

Hurc 40 and Hurc 18 problems getting full throttle from motor

Set up: hitec Flash 5 transmitter and hitec 555 receiver ; E Max GF 2215/15 motor (kv 1470 max current 24 amps) 2 Futaba S133servos; 7-5 APC electric prop.
Tried both Hurc 40 and Hurc 18 with this set up. 1300 30c 3 cell lipo. Only drawing 6.5 amps and 70 watts at full throttle with both esc-should be getting at least
16-17 amps at full throttle. Any thoughts?

Thanks

cvint

04-11-2014 04:52 AM

Ordered Hurc programming card-hope this will solve problem.

cvint

04-15-2014 10:03 AM

Used the Hurc programming card and got the hurc 18 working.I need to work on Hurc 40

All times are GMT -8. The time now is 12:58 PM.