Car Nitro & Gas Engines Discuss all aspects of Nitro and Gas rc car engines here!

OS Max 12CV


Old 03-07-2018, 07:12 PM
Thread Starter
Join Date: Mar 2018
Posts: 1
My Gallery
My Models
My Feedback
Default OS Max 12CV Parts

Hi everyone in the forums, this is my first post here, but been here for a while always reading.

I have an old HPI Nitro RS42 4WD, powered by a OS Max 12CV. The engine has the backplate and the shaft that connect to the crankshaft on the back of the engine that allow to install a coil starter. The issue is the engine does not have it and after reading about coil starters I prefer to stay away because of how often they fail and became useless.

My idea is to have a roto start system but I have been looking around trying to figure out if there is any one compatible for this engine but I have not found any. The back plate has the 4 holes for the screws and those are separated 32mm or 1" 1/4. You guys know any roto starter that will fit for this engine?.

Also, the plastic fuel inlet is broke and I wonder if you guys know any metallic inlet that will fit for the 10E needle assembly. OSMG6993
Click image for larger version

Name:	21481900.jpg
Views:	3
Size:	7.8 KB
ID:	2258043

One last question. I live in Chicago, and I am looking for a good place with an on-road track for this car. Any good place that you guys recommend?


Last edited by Mr.Alvaro; 03-07-2018 at 07:56 PM. Reason: Missing Question
Mr.Alvaro is offline  
Reply With Quote
Old 03-12-2018, 05:08 AM
1QwkSport2.5r's Avatar
Join Date: Oct 2006
Location: Cottage Grove, MN
Posts: 9,308
My Gallery
My Models
My Feedback

There will be two sets of screw holes in the backplate - 4 for holding the backplate to the engine and 4 holes for
holding the starter to the engine. Is the 32mm spacing listed for the smaller set of screws for the actual starter? If so, I may have something that will work, but I will have to look in my parts box. I think I have a Traxxas electric starter setup that may fit.

For the carb fitting - what’s the OD of the needle valve assembly where the fuel inlet fitting goes? I may have a metal fitting that will fit - I just need to know what the size of the needle holder is.
1QwkSport2.5r is online now  
Reply With Quote

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Thread Tools
Search this Thread
Display Modes

Contact Us Archive Advertising Cookie Policy