CEN NX76 Engine Question
#4
Junior Member
Thread Starter
My Feedback: (1)
Join Date: Dec 2003
Location: Katy,
TX
Posts: 12
Likes: 0
Received 0 Likes
on
0 Posts
RE: CEN NX76 Engine Question
Great, that's what I was hoping. I should be able to heat the end of the crank and get that messed up screw out, then.
I'm going to try mounting this engine in a truggy that was built on an Ofna 9.5 Violator chassis. With the extra torque and power of the .46 engine, I'm thinking I should be able to turn a 20-tooth clutch bell with no problem. As to whether the the extra power will offset the increased weight of the bigger engine, we'll see...
I'm going to try mounting this engine in a truggy that was built on an Ofna 9.5 Violator chassis. With the extra torque and power of the .46 engine, I'm thinking I should be able to turn a 20-tooth clutch bell with no problem. As to whether the the extra power will offset the increased weight of the bigger engine, we'll see...