30% Carden Cap Construction Pics
#1
Senior Member
Thread Starter
My Feedback: (2)
Join Date: Jan 2002
Location: Cordova, TN,
Posts: 407
Likes: 0
Received 0 Likes
on
0 Posts
30% Carden Cap Construction Pics
Here are a few pics of my winter project. Carbon landing gear, wing tube and tail gear. 5945's all the way around. 2 on the rudder in an SWB pull pull offset tray. Hoping for < 19lb. 3w-75us for power.
Jess
Jess
#7
My Feedback: (45)
Join Date: Dec 2001
Location: Bartlett,
TN
Posts: 4,811
Likes: 0
Received 0 Likes
on
0 Posts
30% Carden Cap Construction Pics
That looks sweet Jess..... Looks like you've put a lot of work into it.... I'd like to see how they engineered the whole wing tube thing.... I wasn't very happy with the way my SuDoKhoi 60 was engineered...
#11
Senior Member
My Feedback: (29)
Join Date: Jan 2002
Location: Amarillo,
TX
Posts: 331
Likes: 0
Received 0 Likes
on
0 Posts
30% Carden Cap Construction Pics
Jess:
Can you tell me how you cut the hole in the balsa sheeting for the wing tube. I'm building a 35% Carden Edge and I'm trying to figure out the best way to make a clean cut.
Can you tell me how you cut the hole in the balsa sheeting for the wing tube. I'm building a 35% Carden Edge and I'm trying to figure out the best way to make a clean cut.
#12
My Feedback: (6)
weight
I haven't got an accurate scale.
On the bathroom job it weighs in at 20.5lbs, that's with a KS cannister slung under the belly. The cannister probably adds close to a #.
My flying field is very noise sensitive and with the 3-blade Mejzlik and KS cannister the plane is whisper quiet.
Mike
On the bathroom job it weighs in at 20.5lbs, that's with a KS cannister slung under the belly. The cannister probably adds close to a #.
My flying field is very noise sensitive and with the 3-blade Mejzlik and KS cannister the plane is whisper quiet.
Mike
#13
Senior Member
Thread Starter
My Feedback: (2)
Join Date: Jan 2002
Location: Cordova, TN,
Posts: 407
Likes: 0
Received 0 Likes
on
0 Posts
Holes
rthorne,
My hole was pre-drilled on the Cap kit. The fuse sides are 90 degrees to the wing-tube.
As I understand the edge, the fuse angles and are not 90 degrees.
I did, however cut lightening holes in some balsa sheets with a dry wall hole cutter in the drill press. Just back up the balsa with ply wood so the balsa does not splinter. Then sand. Works great.
Jess
My hole was pre-drilled on the Cap kit. The fuse sides are 90 degrees to the wing-tube.
As I understand the edge, the fuse angles and are not 90 degrees.
I did, however cut lightening holes in some balsa sheets with a dry wall hole cutter in the drill press. Just back up the balsa with ply wood so the balsa does not splinter. Then sand. Works great.
Jess