stabilizer slack
#1
Thread Starter
My Feedback: (109)
stabilizer slack
I am assembling this Yak-I notice the stabilizer halves when tighten fully they seem to be a loose fit toward the trailing edge against fuse-they seem to move back and forth at the trailing edge when pulled from outside edge -any comments would be welcomed-thanks
#2
Senior Member
My Feedback: (17)
Join Date: Jul 2003
Location: Boisbriand,
QC, CANADA
Posts: 1,592
Likes: 0
Received 0 Likes
on
0 Posts
RE: stabilizer slack
My 35% 260 did the same thing after 150 flights. I have simply put some drops of thin CA over the stab tube to fill the gap between the tube and stab tube.