Carden 30% Cap 232
Going to build one next month. Would like some feedback on what motor your using and advice on setup (pull pull-CG-weight)
Thanks, Carroll |
RE: Carden 30% Cap 232
Carroll, here is a link.
[link=http://www.rcuniverse.com/forum/m_533066/mpage_1/key_/tm.htm]30% carden cap[/link] I removed the Pull-Pull and put the rudder servos in the tail for a more aft CG. I will post the pics on that thread later today. Jess |
RE: Carden 30% Cap 232
Thanks Jess for the feedback and pictures. That's a good lookin plane you built. I noticed that you went with the 3W 75 for power.
I had the 3W 75 rear Induction and it was a pain to break in with several dead sticks at first and then it was pretty reliable. Do you think the 3W 75 would be a better choice say over the Brison 4.2? They both weigh about the same except for the 75I which weighs a little more than the 75us version. Carroll....... |
All times are GMT -8. The time now is 11:04 PM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.