Atlanta
Personal choice Iguess.
Doug
That is EXACTLY what I'm talking about ! ! ! ! ! ! Now everyone, please excuse me while I shut down my computer so I can clean up my mess from drooling all over my keyboard.......LOL
David
I am looking forward to my new Arrow kit from Don. He's already shipped 5 kits I think he told me, and they now have bulkheads installed. (He says the European, Med and Middle Eastern guys love 'em. Wolfgang Matt must be popular, I love it too.)
His kits have really come along quickly and get better and better. And so many different designs available. He's made 20 molds, or more, of full fuselage kits in what, 3 years? And those are just the Classics, he does Giant Scale stuff too. How does he do it? He's a machine!
Chris...
John
I was having the same problem with my YS45. Would run like crap as I tried to go to full throrttle or would just quit. I replaced all the gaskets, o-rings, and silcone parts but haven't had a chance to run it yet, hopefully It will solve the problem. What lead me to do this was mainly the fact that I could only get 2lbs of tank pressure.
According to the RCM Ys 60 article the engine won't run right unless the tank pressure is between 6 to 8lbs. So this led me to the regulator plunger on the bottom of the engine. On my YS 45 the regulator plunger was in two pieces.
The plastic or silcone piece that is on the metal pin just fell off. I'm not sure if this was the cause so I decided to replace all the soft parts to make sure. Main reason for replacing all the soft parts is if the crankcase has a leak you will never get enough pressure to pressurize the tank to the optimal value. This is why I basically rebuilt the engine with all new soft parts.
I did a test with my Robart retract pump (with presure gauge) after I started having problems by placing a tee in the pressure line between the check valve and tank and connecting the pump line to the tee. I used an electric starter to turn the engine over for about 20 seconds and couldn't get more than 2lbs of pressure which i didn't think was right. I next use the retract pump to pump up the tank to 10lbs and didn't lose a 1/2 pound after letting it sit for 30 minutes. So at the the pressurized tank and check valve part of the system was in good order.
Below is a diagram from the manual that I put together to show the pumped air direction and the fuel direction. I don't quite get what part your trying to blow air though so I though this diagram may help.
I hope to put mine on the test stand this weekend to see if the problem is fixed.
Bryan
Here is a closer look at the 3 chamber YS pressurized Fuel Delivery System via diagram and the actual internal parts.
<o></o>
Bryan has it right, you need to see 6 to 9 psi pressure for the engine to run correctly, it always comes back to the regulator when these motors are having this issue. You should notice that the fuel tank expands.
<o></o>
These regulator screws were usually factory set and only are intended for very small adjustments to the low speed mixture, start out setting your regulator screw protruding from the body to 0.009 to 0.010 of an inch.
<o></o>
To increase the regulated pressure you need to reduce spring compression by going counter clockwise with the brass adjustment screw, in other words rich, it’s opposite what you would normally think.
<o></o>
Even though you’re getting fuel shooting out, pressure still can be low. For example running a regular engine with only pipe pressure and a one way check valve will give you fuel shooting out when you disconnect the fuel line.
<o></o>
Have you tried leaving the igniter on the glow plug during you throttle up test runs?
<o></o>
By the way what plug are you using?<o></o>[/i]