Aluminum Speed/13 with 2" rise
#1
Member
Thread Starter
Join Date: Feb 2013
Location: Reno,
NV
Posts: 36
Likes: 0
Received 0 Likes
on
0 Posts
Aluminum Speed/13 with 2" rise
Leo has the combo on now for $135.00 including the 2" rise header. Now I"m going to have to order another plane...
Question, has anyone run this engine in an inverted configuration yet?
tt
Question, has anyone run this engine in an inverted configuration yet?
tt
#3
Join Date: Feb 2006
Location: Rose HIll,
KS
Posts: 523
Likes: 0
Received 0 Likes
on
0 Posts
RE: Aluminum Speed/13 with 2
I just received this beauty! The quality, the price, and Leo's prompt service are outstanding. I have not decided on an airframe for this engine yet much less run it inverted so I can't help with OPs question.
If I may, I'd like to add another question to this thread: can anyone offer advice on the setup and operation of the in-flight high-speed needle valve?
If I may, I'd like to add another question to this thread: can anyone offer advice on the setup and operation of the in-flight high-speed needle valve?
#4
My Feedback: (5)
RE: Aluminum Speed/13 with 2
JMB52760
I have mine on a flap channel. It works in reverse of what we are used to and takes a lot of throw to make small changes. I set mine up with needle set at just rich of max RPM. I can adjust in the air as the day goes on from the TX. This is a nice feature.
I have mine on a flap channel. It works in reverse of what we are used to and takes a lot of throw to make small changes. I set mine up with needle set at just rich of max RPM. I can adjust in the air as the day goes on from the TX. This is a nice feature.