CAD forays
#1
Thread Starter
Join Date: Feb 2006
Location: Dorr, MI
Posts: 1,457
Likes: 0
Received 0 Likes
on
0 Posts
CAD forays
I've been experimenting with TurboCAD, and thought I'd share some results. I haven't been flying for a few years (pers'nal reasons, y'know) - but that's about to change. I didn't use a micrometer to take measurements, I just used a ruler and guestimated. I figure the measurements should be close enough to design models to put them in. The subjects are an HP.61, a Norvel .061, and a Norvel .074.
#4
Thread Starter
Join Date: Feb 2006
Location: Dorr, MI
Posts: 1,457
Likes: 0
Received 0 Likes
on
0 Posts
RE: CAD forays
I don't do this for a living, as my handle implies, I'm a professional truck driver. This is strictly hobby for me. I haven't had any official training, just the learning materials that came with the software. I used to do some drafting using just a steel ruler and a pencil, so it's not TOTALLY foreign to me.
#9
RE: CAD forays
What TurboCad version do you have? I have Deluxe V11 and have just started to tabble in it. I was trying to do some 3D solids but couldn't get it to work. I'm sure it has the capability just haven't been able to spend alot of time on it.
skeeter
skeeter