JIMESTES

My Feedback: (8)

Here is my super sportster 40
in St. George for it's photo shoot.
Go to my Gallery to see more of it.
The canopy was done with Rit Dye.
Later Jim

JIMESTES

My Feedback: (8)

...

Gastronom-RCU

My Feedback: (5)

Is this paint on monokote or monokote on monokote?? Looks killer, may be ahrd to see in the air at a distance..

JIMESTES

My Feedback: (8)

Monokote on Monokote
It has a real visible bottom with a three inch black stripe tip to tip on the main wing and a two inch one on the stab all on solid white back ground you can see it pretty good.
later Jim

Mike Bogh

My Feedback: (14)

Very, very nice plane, Jim.
Just beautiful.

Buz^

My Feedback: (2)

look's great, maybe turn it over and add a pic of the bottom, so the guy's can see it.

JIMESTES

My Feedback: (8)

I am sorry I have not taken any finished photo's of the bottom of the plane here is one that dosen't have the horizontal stripe or the super sportster decals on the wing. I will take some and post at a later date.
later Jim

JIMESTES

My Feedback: (8)

Here is a picture of the finished bottom

JIMESTES

My Feedback: (8)

specs:
Great Plains Super Sportster kit.
Covered with Monokote.
Enlarged and reshaped the rudder and a Sullivan tail wheel.
It is wearing a Hitec flight pack and Magnum 46 with APC 11X5 prop,, a over sized great plains 14 oz fuel tank and on board volt watch I left the wheel pants off because of flying off of a rolled road base runway.
Mine came out finished weight of 5.5 lbs after adding 3 oz of buck shot and epoxy to the built up nose cowling.
What has everyone else's weighed?

Robotech

My Feedback: (9)

I finished this one about a year ago.

Robotech

My Feedback: (9)

Another

JIMESTES

My Feedback: (8)

Looks good almost as good as mine
What do yo have on the bottom?
Later Jim