What...................carbon fiber to fiber glass
#1
Thread Starter
My Feedback: (4)
Join Date: Sep 2005
Location: napa,
CA
Posts: 242
Likes: 0
Received 0 Likes
on
0 Posts
What...................carbon fiber to fiber glass
makes the best bond between carbon fiber and fiber glass that was previously resined? Cryocynate (super glue) or epoxy. And how to best prepared the surface. I'm leaning towards cryocinate. What say you fellow airmen?
Thanks all
M0f0sheee
Thanks all
M0f0sheee
#2
Senior Member
Join Date: Jan 2011
Location: Cody,
WY
Posts: 294
Likes: 0
Received 0 Likes
on
0 Posts
RE: What...................carbon fiber to fiber glass
A properly prepared joint with a quality epoxy resin is the best. You need to sand both surfaces with 80 grit sandpaper and clean them with acetone. 5,10,15 minute epoxies don't do a very good job quite honestly. A quality bonding epoxy (3M or Hysol) or a reinforced and thickened laminating epoxy will perform better than CA.
If you don't want to prepare the joint and don't want to buy a good resin and the appropriate fillers (cab-o-sill, cotton flock) then use CA.
If you don't want to prepare the joint and don't want to buy a good resin and the appropriate fillers (cab-o-sill, cotton flock) then use CA.