Mold Maker Wanted
09-23-2003, 03:41 PM
#1
Senior Member
Thread Starter
Join Date: Mar 2002
Location: Rocklin, CA
Posts: 263
Likes: 0
Received 0 Likes
on
0 Posts
Mold Maker Wanted
Hi all,
I’m looking for a mold maker who is interested in building a fuselage mold for a model jet manufacturer. The project is a fuselage that is approx 40” long and 8-12” wide.
What I’m looking for is the fuselage male plug only. I have the cross sections for you to start with and the rest is up to your good judgment. As far as a surface finish, I’d like a fiberglass surface, ready for waxing.
Please email me if you’ve built these before, are looking for a new project, and are looking to make a little money.
Thanks
Russ
[email protected]
Oakdale Aircraft
I’m looking for a mold maker who is interested in building a fuselage mold for a model jet manufacturer. The project is a fuselage that is approx 40” long and 8-12” wide.
What I’m looking for is the fuselage male plug only. I have the cross sections for you to start with and the rest is up to your good judgment. As far as a surface finish, I’d like a fiberglass surface, ready for waxing.
Please email me if you’ve built these before, are looking for a new project, and are looking to make a little money.
Thanks
Russ
[email protected]
Oakdale Aircraft
10-09-2004, 07:28 PM
#4
Junior Member
Join Date: Nov 2003
Location: Montgomery,
AL
Posts: 17
Likes: 0
Received 0 Likes
on
0 Posts
