Landing gear on a sheeted foam wing
I'd like to put landing gear on a thin sheeted obeechi wing. It's a low wing plane with about a 38 inch span. Should I glass the area that I'll be attaching the gear two? Any hints would be appreciated. I just can't get myself to handlaunch a low wing craft with a small prop. I just know that sooner or later I mess up the launch.
|
RE: Landing gear on a sheeted foam wing
Read this thread in detail, might give you some ideas.
http://www.rcuniverse.com/forum/m_20..._isobar/tm.htm |
All times are GMT -8. The time now is 09:55 AM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.