carb block off screw
#1
Junior Member
Thread Starter
Join Date: Jun 2003
Location: manassas,
VA
Posts: 12
Likes: 0
Received 0 Likes
on
0 Posts
carb block off screw
Hi,
I purchased a Jett 60L a number of years ago. I recently purchased the universal remote needle. What size screw is needed
to intert in the carb where the needle was originally located. I did a search and came up with 3/56 1/2in. Is this correct
for the Jett 60L?
thanks for the info,
djt294
I purchased a Jett 60L a number of years ago. I recently purchased the universal remote needle. What size screw is needed
to intert in the carb where the needle was originally located. I did a search and came up with 3/56 1/2in. Is this correct
for the Jett 60L?
thanks for the info,
djt294
#2
My Feedback: (19)
Join Date: Apr 2002
Location: Cleveland,
OH
Posts: 5,576
Likes: 0
Received 0 Likes
on
0 Posts
RE: carb block off screw
Yes, I believe that is the right size.
What some folks have done is install the stock needle installed out 5-6 turns- and just lock it down with the nut (if you have room).
Bob
What some folks have done is install the stock needle installed out 5-6 turns- and just lock it down with the nut (if you have room).
Bob