Li po's with a Promax brushed motor
#1
Thread Starter
Li po's with a Promax brushed motor
I have a old Zagi that was using 9.6v, 800ma Ni Cad batteries.
Since I now have some 11.1v, 900 Ma, Li Po's ratted at 25c.
Do you thing these will work with the old Promax Cobalt brushed motor????
Larry
Since I now have some 11.1v, 900 Ma, Li Po's ratted at 25c.
Do you thing these will work with the old Promax Cobalt brushed motor????
Larry
#2
Thread Starter
RE: Li po's with a Promax brushed motor
Never mind a answer, I figured it out myself
The answer is............
Drum roll please
The ESC for a brushed motor shut off is 5.4Vdc. This would put a 11.1v Li Po below the 3vdc per cell limit[:-]
Thank you very much....
I'll be here all week, please come again
Larry
The answer is............
Drum roll please
The ESC for a brushed motor shut off is 5.4Vdc. This would put a 11.1v Li Po below the 3vdc per cell limit[:-]
Thank you very much....
I'll be here all week, please come again
Larry