GY 520 installation on the Blade 400
#1
Senior Member
Thread Starter
Join Date: Sep 2008
Location: Benin City, Edo StateEdu State, NIGERIA
Posts: 131
Likes: 0
Received 0 Likes
on
0 Posts
GY 520 installation on the Blade 400
I purchased a GY520 gyro and S9257 servo combination. The enclosed booklet form Futaba is not very clear where the red and black leads included must be inseted into the plug on the wire lead. The lead from the servo position is clear as there is only one opening. Also where must the leads from the gyro be pugged into the stock Spektrum receiver.
See the picture of the plug as installed on the Blade 400 attached. Note the two openings facing upwards.
Also is there any place where I can find the setup parameters for the Gyro with a stock S[ektrum receiver on the Blade 400.
See the picture of the plug as installed on the Blade 400 attached. Note the two openings facing upwards.
Also is there any place where I can find the setup parameters for the Gyro with a stock S[ektrum receiver on the Blade 400.
#2
Senior Member
Join Date: Jun 2010
Location: Sydney, AUSTRALIA
Posts: 4,786
Likes: 0
Received 0 Likes
on
0 Posts
RE: GY 520 installation on the Blade 400
ORIGINAL: tandem4
I purchased a GY520 gyro and S9257 servo combination. The enclosed booklet form Futaba is not very clear where the red and black leads included must be inseted into the plug on the wire lead. The lead from the servo position is clear as there is only one opening. Also where must the leads from the gyro be pugged into the stock Spektrum receiver.
See the picture of the plug as installed on the Blade 400 attached. Note the two openings facing upwards.
Also is there any place where I can find the setup parameters for the Gyro with a stock S[ektrum receiver on the Blade 400.
See the picture of the plug as installed on the Blade 400 attached. Note the two openings facing upwards.
Also is there any place where I can find the setup parameters for the Gyro with a stock S[ektrum receiver on the Blade 400.
The lead that has only a single wife should plug into channel 5 (for use with your gyro switch)
The servo then plugs into the opening as you described..
Hope that helps.