Resurecting original Blade CX
 

Well, I found my old Blade CX in the basement and I'm thinking about resurecting it. It was a fun little heli until it had the 4-in-1 fail. The 4-in-1's were expensive then and money was short so it just sat. Now I'd like to get it flying again. I've found some things on the internet that say it may be possible to repair the 4-in-1 but, if that does not work out I'm looking at other options. One thought that occured to me is; "Is it possible to retro fit one of the 4/5-in-1's from the CX2 into a CX? What all is involved - other than it will need a Spektrum tx? Would motors and servos need changed too? Has anyone done this yet or have any suggestions?