Midwest Hots E resurrection.
03-21-2010, 02:06 PM
#1
Junior Member
Thread Starter
My Feedback: (1)
Join Date: Jun 2005
Location: Manchester,
TN
Posts: 3
Likes: 0
Received 0 Likes
on
0 Posts
Midwest Hots E resurrection.
I am attempting to resurrect a Hots electric. I don’t have plans or the manual.
What I am looking for is suggestions for CG, how much down thrust, right thrust, prop size.
I plan on installing an e-flite 450 outrunner. Any help would be appreciated.
What I am looking for is suggestions for CG, how much down thrust, right thrust, prop size.
I plan on installing an e-flite 450 outrunner. Any help would be appreciated.
03-21-2010, 05:55 PM
#2
Senior Member
RE: Midwest Hots E resurrection.
Hi,
The CG is 3-3/8" measured from the LE back with about +/- 1/8" range.
Check out this [link=http://www.dansantichmodels.net/]site[/link] for more information. You should be able to e-mail them for more information.
Good luck!
The CG is 3-3/8" measured from the LE back with about +/- 1/8" range.
Check out this [link=http://www.dansantichmodels.net/]site[/link] for more information. You should be able to e-mail them for more information.
Good luck!
