is a R600 receiver pcm
#1
Thread Starter
My Feedback: (7)
is a R600 receiver pcm
This JR R600 receiver I inherited , I tried to set it up to a Neon Hitec FM 72 Mhz radio same channel #40 and it wont work at all , so next I removed the crystal and installed it into a different receiver, and the JR crystal in a different receiver worked with the Hitech radio so I tried the R600 JR receiver also to a Futaba radio set on PPM and it did not work , I know both of my radios are negative shift , so maybe the reason for not working is that the R600 JR receiver is a positive shift or could this JR receiver be a PCM modulation that don't match a PPM radio?
#3
Thread Starter
My Feedback: (7)
RE: is a R600 receiver pcm
ORIGINAL: BarracudaHockey
The 600 is shift selectable, do you have it selected correctly?
The 600 is shift selectable, do you have it selected correctly?
TRANSMITTER T4YF
(2 sticks, 4 channels, FM transmitter)
Transmitting frequency: 29, 35, 36, 40, 41,
50, 60, 72, 75 MHz
Modulation method: FM (Frequency Modulation)
Power requirement: 12V (penlight battery
x8) or 9.6V nicd battery
Current drain: 180mA
SERVO S3003/S3004
(Standard servo)
Power requirement: 4.8V or 6V (common
with receiver)
Current drain: 8mA (idle)
Output torque: 3.2kg-cm (4.8V)
Operating speed: 0.23sec/60 degree (4.8V)
Size: 40.4x19.8x36mm
Weight: 37.2g
RECEIVER R136F(not for USA)
(6 channels, FM receiver)
Receiving frequency: 29, 35, 36, 40, 41, 60,
72 MHz
Intermediate frequency: 455kHz
Receiver image
http://static.rcgroups.net/forums/at...P101005250.jpg
#6
My Feedback: (11)
RE: is a R600 receiver pcm
ORIGINAL: suzonka
how do I do the shift selection on it ? thanks for your help
ORIGINAL: BarracudaHockey
I'm not asking you if its shift selectable, I'm telling you that it is.
I'm not asking you if its shift selectable, I'm telling you that it is.
http://www.horizonhobby.com/pdf/JR_RS600_manual.pdf
#7
Thread Starter
My Feedback: (7)
RE: is a R600 receiver pcm
ORIGINAL: BarracudaHockey
My pleasure. Here you go...
http://www.horizonhobby.com/pdf/JR_RS600_manual.pdf
ORIGINAL: suzonka
how do I do the shift selection on it ? thanks for your help
ORIGINAL: BarracudaHockey
I'm not asking you if its shift selectable, I'm telling you that it is.
I'm not asking you if its shift selectable, I'm telling you that it is.
http://www.horizonhobby.com/pdf/JR_RS600_manual.pdf