?lost model alarm?
#1
Thread Starter
My Feedback: (2)
Join Date: May 2004
Location: Laramie,
WY
Posts: 205
Likes: 0
Received 0 Likes
on
0 Posts
?lost model alarm?
digi-alarm is the one im interested in but im not sure it will work for my application,it says no more than 6 volt.
im using thunder-pow 3s, pheonix25 & hitec radio.does any body know where i can get an alarm for my setup?
im using thunder-pow 3s, pheonix25 & hitec radio.does any body know where i can get an alarm for my setup?
#2
Senior Member
Join Date: Jun 2002
Location: West Coast,
CA
Posts: 536
Likes: 0
Received 0 Likes
on
0 Posts
RE: ?lost model alarm?
All of the lost model alarms that I have seen plug into the Rx just like a servo. The BEC feature of the Phoenix 25 supplies 5.0VDC to the Rx. So, you are good to go if the Digi-Alarm works like all the other LMA's.
RC-CAM
RC-CAM
#3
Thread Starter
My Feedback: (2)
Join Date: May 2004
Location: Laramie,
WY
Posts: 205
Likes: 0
Received 0 Likes
on
0 Posts
RE: ?lost model alarm?
thank you i .i spent 2 hours looking for my ship only to have some one else notice it in an area i never considered,with a li-polly drained way too low but possibly(knock on wood) salvageable.ill contact digi-alarm for more info.
#4
My Feedback: (2)
RE: ?lost model alarm?
If you are interested here is an article on lost model alarms and battery monitors:
http://www.rcezine.com/cms/article.p...featured&id=67
http://www.rcezine.com/cms/article.p...featured&id=67