n1369e

Help with settings for HiMax 6330-210 pro. Does anyone have these settings? Or advice, I’m still learning the controller.

ltc

My Feedback: (3)

Contact Mike at f3aunlimited
I think he is flying that combo in one of his planes (BJ Craft Passion I think)

Also, do you have a Jetibox for programming the Mezon?

n1369e

Yes I have a box, I talked to mike when I bought it and all he could remember at the time was the timing. I found some setting from rc groups, Andrew J, but some need some explaining to me I would think.

ltc

My Feedback: (3)

If you got the settings from Andrew Jesky, you should be all set
I assume your Pro is the newer version with 20poles (versus 14 for the original)

Did you download the Mezon documentation or have the original manual?
It walks you thru all the settings via Jetibox

If it's your first time setting up a Mezon, send a PM if you have any questions.

flyboy91

My Feedback: (1)

These should get you very close and is what i use

Timing 24 degrees
Pole count 20
PWM 8Hz
Break manual
40% start power
brake delay 0.0
end power 60%
brake speed .1
Auto Cut off
3.0v per cell
Initial end point Auto
High end point 1.9
BEC voltage 8.0

andrew

n1369e

Thanks Andrew, Congratulations on your finish at the worlds and to the team.

flyboy91

My Feedback: (1)

Thank you very much! We were so happy to be able to have all 4 pilots in the finals.

The only setting on your esc you might change is the down line breaking 40 start and 60 end is pretty strong breaking so you may find you want to reduce that depending on model and prop.

Andrew