New blades wont fit
#1
Senior Member
Thread Starter
Join Date: Dec 2006
Location: Where the Navy needs me,
TN
Posts: 552
Likes: 0
Received 0 Likes
on
0 Posts
New blades wont fit
I bought some main blades for my falcon 40 v2. When I took off the stock and put that lil adaptor in the new blades. The new blades have a slightly larger hole, and are about 1 inch longer. When I install the blades on, there is a lil bit space cause I can move the blades a bit. I found out I can't tighten the blades. The adaptor just spins around the blade. Can I put a bit of CA where the adaptor and the blades meet? Here is the link to the blades I bought https://www.ushobbysupply.com/produc...products_id=36
#2
Senior Member
Join Date: Jul 2006
Location: Takoma Park,
MD
Posts: 1,793
Likes: 0
Received 0 Likes
on
0 Posts
RE: New blades wont fit
That is an interesting problem. I pinged walkera to see, I am waiting for an answer. If they dont work out, I will of course take them back for full refund.
Michael
Michael