is this ok?
I bought this from GOGO. RC, the stainless piece that holds the blade holders is not drilled straight, I was told this is ok, would you guys use it? You can see that the blades holders are not parallel with the v block behind it
https://cimg9.ibsrv.net/gimg/www.rcu...09ade9a662.jpg https://cimg0.ibsrv.net/gimg/www.rcu...a3bbc0e308.jpg |
I would say no way, those tail blades will not track right and setup quite the vibration. I have bent the tail yoke (spindle shaft) and it had a crazy high freq vibration that freaked the gyro out.
|
If there is no vibration it means that everything is okayif. Otherwise you should go to a specialist.
|
All times are GMT -8. The time now is 06:07 AM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.