am I over-propping this setup?
#3
Senior Member
Join Date: Dec 2002
Location: Chattanooga,
TN
Posts: 2,198
Likes: 0
Received 0 Likes
on
0 Posts
RE: am I over-propping this setup?
As Matt says - it is just off their charts, but why not put a Whattmeter on it and see what the current draw really is - if it is less than 8A you are probably okay [that would be ~50-55W-in which should be fine for a 350C motor].
Cheers, Phil
Cheers, Phil
#4
Member
Thread Starter
My Feedback: (1)
Join Date: Nov 2003
Location: Athens, GA
Posts: 94
Likes: 0
Received 0 Likes
on
0 Posts
RE: am I over-propping this setup?
Hmm, I wish I had a whattmeter. My VOM doesn't measure amps, either, or I'd test it that way. I picked up a selection of props today at the LHS. Unfortunately, the only one that will fit without an adapter is a 10x4.7. I think it will work though. Motorcalc predicts that this prop will draw 8.2 amps peak (56.1 W) and produce 13.9 oz of thrust. My Dandy weighs about 12 oz., and this combo will let it climb vertically. I tested it tonight in my bedroom... it'll climb right out of your hand if you let it.
I'll probably also use a 9x4.7 prop to get the amps down to about 6.5 and increase the run time. I'll still have 10.7 oz of thrust to play with.
Thanks,
Matt
I'll probably also use a 9x4.7 prop to get the amps down to about 6.5 and increase the run time. I'll still have 10.7 oz of thrust to play with.
Thanks,
Matt