Help choosing a model???
#1
Member
Thread Starter
Join Date: Jul 2005
Location: KendalCumbria, UNITED KINGDOM
Posts: 68
Likes: 0
Received 0 Likes
on
0 Posts
Help choosing a model???
I have an Axi 2212/34 and suitable speed controller and a few 1000mah 11.1v Lipo cells out of a foamy biplane that flies like a carrier bag – its far too bendy and a generally poor design.
What kit – ARTF – would you suggest to make good use of this engine and batteries etc.
I prefer something aerobatic as opposed to a glider type thing doesn’t have to be full on 3d either.
Any suggestions?? (Available in UK)
What kit – ARTF – would you suggest to make good use of this engine and batteries etc.
I prefer something aerobatic as opposed to a glider type thing doesn’t have to be full on 3d either.
Any suggestions?? (Available in UK)
#2
Senior Member
Join Date: May 2006
Location: Rancho Santa Margarita, CA
Posts: 1,590
Likes: 0
Received 0 Likes
on
0 Posts
RE: Help choosing a model???
I believe these would be an option
http://www.e-fliterc.com/Products/Te...ProdID=EFL2400
http://www.e-fliterc.com/Products/Te...ProdID=EFL2200
The batteries are going to have a low flying time with only 1000mah, so the first plane might be a little better suited
http://www.e-fliterc.com/Products/Te...ProdID=EFL2400
http://www.e-fliterc.com/Products/Te...ProdID=EFL2200
The batteries are going to have a low flying time with only 1000mah, so the first plane might be a little better suited