LAMA V3 collet/blade grip question
Hey guys,
I have a E-Flight Blade CX2 and was wondering if the up-graded CNC aluminum E-Sky LAMA V3 collets / blade grips would fit a CX2. Anyone try this or have both heli's that could check fitmit?? http://cgi.ebay.com/Esky-Lama-V3-CNC...QQcmdZViewItem BTW, I know Vortex stuff works on the CX2, and MicroHeli makes CNC'ed grips, was just looking for something different (purple bling) and I noticed the upper and lower ball joints on the blade grips are same size on the LAMA were the CX2 are different from upper to lower rotor. There might be a performance gain for the CX2 using LAMA blade grips due to the ball joint placement depending on how different it is from the CX2. Thanks, ~Mike............ |
RE: LAMA V3 collet/blade grip question
No body? Well, anyone have the up-graded grips that can either mic the grips for me or perhaps ship me the old plastic ones for the cost of shipping?
TIA ~Mike........ |
RE: LAMA V3 collet/blade grip question
Mike, I have all the upgrades except the blade grips. I know someone has some so come on and help Mike out.
Greg |
RE: LAMA V3 collet/blade grip question
A friend wanted folding blades on his CX, so he put stock E-Sky V3 collets and Xtreme blades on his CX and it flies fine. Don't know if it will fit the CX2, but I suspect it would. Also, don't know if the CNC Lama parts will fit the CX, but again I suspect they would.
I put all CNC parts on my Lama V3 and the results were horrible. Went back to all stock except for the center shaft to keep the flybar from popping out. |
All times are GMT -8. The time now is 08:18 PM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.