J'EN .54 diesel
#1
Thread Starter
J'EN .54 diesel
Here's conversion done of a Chinese motor by Just Engine UK.
The venturi has been further restricted to 1/16 ID. The manifold was plumbed to the wheel and the plane is extremely clean. The project was the restoration of a silked Anderson built in 1990. Its covering was badly rotted and the balsa is brittle. Lots of Thermalspan patches and a single coat of Klass Kote.
On 20cc, it runs 12mins at about 3,900rpm. It gets really small!
The venturi has been further restricted to 1/16 ID. The manifold was plumbed to the wheel and the plane is extremely clean. The project was the restoration of a silked Anderson built in 1990. Its covering was badly rotted and the balsa is brittle. Lots of Thermalspan patches and a single coat of Klass Kote.
On 20cc, it runs 12mins at about 3,900rpm. It gets really small!