DX6i SETUP FOR RAPTOR G2
11-21-2008, 08:22 PM
#1
Senior Member
Thread Starter
Join Date: Jan 2008
Location: BARTLETT,
TN
Posts: 181
Likes: 0
Received 0 Likes
on
0 Posts
DX6i SETUP FOR RAPTOR G2
Andy - I just purchased the Spektrum DX6i for my Raptor G2. Everything is set with the exception of the pitch servo - it doesn't want to move!!! I have it hooked up in the AUX slot on my AR6100, and I have max settings for movement, yet it only moves approx. +2 degrees max. What do you think is wrong? Gyro is good, aileron and elevator is good; and yes, the servo works. Thanks in advance!
11-24-2008, 03:29 AM
#2
RE: DX6i SETUP FOR RAPTOR G2
did you set the swash type to 1 servo? under the swash menu did you set the range for the pitch?
if your alieron servo and elevator servo is good try plugging them to the aux 1 and see if you still get the +2. If yes, then it's not a servo problem.
Andy
if your alieron servo and elevator servo is good try plugging them to the aux 1 and see if you still get the +2. If yes, then it's not a servo problem.
Andy
ORIGINAL: cjennjr
Andy - I just purchased the Spektrum DX6i for my Raptor G2. Everything is set with the exception of the pitch servo - it doesn't want to move!!! I have it hooked up in the AUX slot on my AR6100, and I have max settings for movement, yet it only moves approx. +2 degrees max. What do you think is wrong? Gyro is good, aileron and elevator is good; and yes, the servo works. Thanks in advance!
Andy - I just purchased the Spektrum DX6i for my Raptor G2. Everything is set with the exception of the pitch servo - it doesn't want to move!!! I have it hooked up in the AUX slot on my AR6100, and I have max settings for movement, yet it only moves approx. +2 degrees max. What do you think is wrong? Gyro is good, aileron and elevator is good; and yes, the servo works. Thanks in advance!
11-24-2008, 07:35 PM
#3
Senior Member
Thread Starter
Join Date: Jan 2008
Location: BARTLETT,
TN
Posts: 181
Likes: 0
Received 0 Likes
on
0 Posts
RE: DX6i SETUP FOR RAPTOR G2
Andy - it was the swash. Set it to one servo, and everything's fine now. Adjusted the pitch, and I'm ready to fly!! Just got to secure everything in place, rx, esc, etc. and I'll be good to go. I'll probably take a pic and post it along with my Belt CP. Thanks for your help.
