Eagle 50 *new flyer pls halp!*
hey guys and gals,
Im new to flying helis, so I picked up an Eagle 50 (new flyer picked up a 3d aircraft, *** was I thinking?) Well, after a few crashes I have goten the hang of it I think, I just having a few problems. Crashes have had me replace 4 main rotor blades, 1 tail boom and 1 piece from 50H03-38. Problems: The Heli now vibrates ALOT, I have tried to adjust it so the blades track as close as I can get them but with no luck. Can somebody post a picture of what Im supposed to be adjusting to make sure Im adjusting the right part? Heli pulls to the right, I adjusted my controler adjuster all the way to the right and it seemed to stop this. There has to be something on the heli I can adjust so I dont have to use my controler for it. when you throttle up on the controler, the blades dont start spinning till you are almost 1/4 of the way up, is this normal? Pleas help me, I would really like to go back to learning how to hover but cant because of these issues. I will be checking this thread as often as I can. |
RE: Eagle 50 *new flyer pls halp!*
The heavy vibration means something is bent. Cant tell if it is tail rotor or main rotor by description , but there is a part that needs to be replaced. The speed at which the rotors spin a slight bend can make flying almost impossible. You need to go through the entire drivetrain and find the culprit. The throttle issue seems to be common with the exceed helis's.
|
RE: Eagle 50 *new flyer pls halp!*
I toredown the Heli last night and found out its the shaft that goes thru the T-Shape holder. From the looks of it, pn 50H03-10 should come with the shaft I need
|
All times are GMT -8. The time now is 07:17 PM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.