EZ MODELS VOODOO
#1
Junior Member
Thread Starter
Join Date: Aug 2003
Location: Alexandria, LA
Posts: 25
Likes: 0
Received 0 Likes
on
0 Posts
EZ MODELS VOODOO
I have a EZ Models Voodoo, it has a Saito 91 in it and I have a APC 12x8 prop on it. Just wondering if anyone could give me some suggestions on what size prop would be the best for it, to get the most speed. The plane has a 54 inch span and weighs about 6lbs. Not sure what rpms the engine turns with the 12x8. Any info would be great.
Thanks Jody
Thanks Jody
#6
Senior Member
Join Date: Nov 2003
Location: Auckland, NEW ZEALAND
Posts: 1,324
Likes: 0
Received 0 Likes
on
0 Posts
RE: EZ MODELS VOODOO
I'd start with a 12x12 - a Saito .91 should pull that to nine and a half grand. Also, try an 11 inch prop with as much pitch as you can find.
#8
Senior Member
My Feedback: (9)
Join Date: Mar 2002
Location: Orange,
CA
Posts: 916
Likes: 0
Received 0 Likes
on
0 Posts
RE: EZ MODELS VOODOO
I have an original EZ Dago Red ARF NIB that I am installing a new OS 91 Pumped Surpass in and a new Slimline inverted pitts muffler. Its a sweet flyer I had one back when Hobby People(Then Hobby Shack) imported them. It had a pumped and piped OS 61 SF it was fast/
Viper
Viper
#12
Senior Member
My Feedback: (9)
Join Date: Mar 2002
Location: Orange,
CA
Posts: 916
Likes: 0
Received 0 Likes
on
0 Posts
RE: EZ MODELS VOODOO
EZ Dago Red, any ideas for prop sizes to try on my Dago Red I am running a new OS 91 Surpass II with a pump I was thinking to start with an APC 13x8 and maybe an ALC 12x10? Any ideas I havent tried any of the newer wood props out any suggestions on props?
Thanks Viper
Thanks Viper
#13
Junior Member
Thread Starter
Join Date: Aug 2003
Location: Alexandria, LA
Posts: 25
Likes: 0
Received 0 Likes
on
0 Posts
RE: EZ MODELS VOODOO
Sorry for the delay on replying to your question. I bought the plane off of ebay, it came with the engine, retract servo and alerion servos. All I had to do is install throttle,rudder and elevator servo and receiver. Not to bad for $300.00 dollars, I thought. ai think you still can buy these from MRC still, they go for $300.00 just for the kit.
Thanks Jody
Thanks Jody