prop help
#2
My Feedback: (19)
Join Date: Apr 2002
Location: Cleveland,
OH
Posts: 5,576
Likes: 0
Received 0 Likes
on
0 Posts
RE: prop help
ORIGINAL: handyman
t/t 46 with macs pipe 30% fuel coolpower, bokeer bearing, whats a good prop for this
t/t 46 with macs pipe 30% fuel coolpower, bokeer bearing, whats a good prop for this
Considering the forum you are asking in here... and making an assumption for a moment that you have the MACs pre-tune pipe setup...
That setup is tuned for approximately 16,000 rpm.
I would start off with a 10x6
From there if you are looking for a bit of speed, move to an APC 9x7 and perhaps a 9x8
Find peak rpm on the ground, back off on the needle about 500-600 rpm before flight.
Bob
#4
RE: prop help
ORIGINAL: freakingfast
That 30% may be too high for that engine. It could run hot and make less power.
That 30% may be too high for that engine. It could run hot and make less power.
kc