Viper landing gear mod
#1
Senior Member
Thread Starter
My Feedback: (5)
Join Date: May 2002
Location: Arlington,
TX
Posts: 548
Likes: 0
Received 0 Likes
on
0 Posts
Viper landing gear mod
After finishing the Viper conventional tail version, I thought I'd work on the fuse with the busted landing gear. I've only broke one landing gear out, but that's enough! I used 1/4" ply and replaced the stock one. If only Great Planes would use some of our mods to make these better, or just offer a kit...
Still need to finish the bottom sheeting.
Still need to finish the bottom sheeting.
#2
Senior Member
Join Date: Mar 2005
Location: killeen,
TX
Posts: 442
Likes: 0
Received 0 Likes
on
0 Posts
RE: Viper landing gear mod
I usually just glass the inside of the landing gear block with 4oz glass and install 1/4 20 nylon bolts. Never had any issues with this mod.
#4
Senior Member
Join Date: Aug 2002
Location: HamiltonQueensland, AUSTRALIA
Posts: 149
Likes: 0
Received 0 Likes
on
0 Posts
RE: Viper landing gear mod
In addition to pulling the landing gear block out of the fuselage, we also used to loose the wheels off the axles. Our fix for this problem was to solder washers on the end of the axles to hold the wheels on.
The best solution is to throw the Viper landing gear away and replace it with one from Darrol Cady.
The best solution is to throw the Viper landing gear away and replace it with one from Darrol Cady.