fuel priming
#1
Member
Thread Starter
Join Date: Feb 2010
Location: South Dakota,
SD
Posts: 46
Likes: 0
Received 0 Likes
on
0 Posts
fuel priming
I have an earthquake 3.5 and i was wondering if there was a primer for priming the engine for start up. I blow through the exhaust tube, which works fine, but a primer would work better i think.
#2
Join Date: Oct 2007
Location: Afton,
TN
Posts: 990
Likes: 0
Received 0 Likes
on
0 Posts
RE: fuel priming
Just put your finger over the exhaust outlet and pull the starter a few times without the glow ignitor on. It'll push some fuel in the lines and into the carb, enough to get it started.
A couple of company's made primers to go on the tanks but they were dropped due to leakage and other issues. I believe they still make an in-line bulb you can put in to prime it though.
A couple of company's made primers to go on the tanks but they were dropped due to leakage and other issues. I believe they still make an in-line bulb you can put in to prime it though.
#3
My Feedback: (2)
Join Date: Nov 2002
Location: Bellmore, NY
Posts: 337
Likes: 0
Received 0 Likes
on
0 Posts
RE: fuel priming
ORIGINAL: sdnitro
I have an earthquake 3.5 and i was wondering if there was a primer for priming the engine for start up. I blow through the exhaust tube, which works fine, but a primer would work better i think.
I have an earthquake 3.5 and i was wondering if there was a primer for priming the engine for start up. I blow through the exhaust tube, which works fine, but a primer would work better i think.
http://urchobby.com/proddetail.php?prod=c22616blue