450 Pro tail rotor drive gear replacement
#1
Member
Thread Starter
Join Date: Oct 2002
Location: Windermere,
FL
Posts: 36
Likes: 0
Received 0 Likes
on
0 Posts
450 Pro tail rotor drive gear replacement
Dinged the tail and stripped the torque tube front drive gear. I have it disassembled, but how do you remove the gear from the drive assembly to replace it? I have the replacement gear in hand, but the manual says that assembly is factory assembled. What's the trick to removing it? Thanks.
#2
Senior Member
Join Date: Nov 2009
Location: Glendale,
AZ
Posts: 1,034
Likes: 0
Received 0 Likes
on
0 Posts
RE: 450 Pro tail rotor drive gear replacement
If it is the one that directly connects to the torque tube, remove 4 screws and pull the whole assy out. Once you do that, the 2 halves can be separated and change the gear(s).
#3
Member
Thread Starter
Join Date: Oct 2002
Location: Windermere,
FL
Posts: 36
Likes: 0
Received 0 Likes
on
0 Posts
RE: 450 Pro tail rotor drive gear replacement
Thanks...I figured that out after I got it out and looked close. Since the manual says it's factory assembled, I didn't realize that it split in half. Got it fixed and back in action.