throttle servo for Nitroplanes Yak54
#1
Thread Starter
Join Date: Feb 2003
Location: Toronto,
ON, CANADA
Posts: 1,243
Received 0 Likes
on
0 Posts
throttle servo for Nitroplanes Yak54
Putting this giant scale yak together and one thing I hadn't noticed before: no slot for the throttle servo.
It's the new/original version (one that does NOT have the tunnel and the elev servos are in the fuse, not the stab).
There is a cutout for the (dual) rudder servo(s) but that's it. Anything forward of that is just a uncut piece of ply with no cutouts.
I've seen where one can make a bracket inside the engine box to mount it but I've never encountered this situation b4.
Then again, I've never finished a Nitroplanesbird b4 either.
Suggestions?
It's the new/original version (one that does NOT have the tunnel and the elev servos are in the fuse, not the stab).
There is a cutout for the (dual) rudder servo(s) but that's it. Anything forward of that is just a uncut piece of ply with no cutouts.
I've seen where one can make a bracket inside the engine box to mount it but I've never encountered this situation b4.
Then again, I've never finished a Nitroplanesbird b4 either.
Suggestions?
#4
Thread Starter
Join Date: Feb 2003
Location: Toronto,
ON, CANADA
Posts: 1,243
Received 0 Likes
on
0 Posts
RE: throttle servo for Nitroplanes Yak54
ORIGINAL: TedMo
This is called model building.
This is called model building.
[:'(]