Duratrax Nitro Quake question
#1
Senior Member
Thread Starter
Join Date: Jun 2005
Location: Pitcher,
NY
Posts: 546
Likes: 0
Received 0 Likes
on
0 Posts
Duratrax Nitro Quake question
I took my fathers nitro quake out for a spin to tune it up after setting all winter. Went good until the muffler fell off the motor and it rev'd up and died. Since then i haven't been able to get it to start again. I checked glow plug and it is fine. It doesn't seem to have any less compression then before. So i am stumped on what caused this to just die and not start up again. Did i blow a gasket on the motor maybe? It is a .21 torque motor. Thanks guys.