jUST THAT QUICK!
#1
Junior Member
Thread Starter
My Feedback: (3)
Join Date: May 2011
Location: baton Rouge,
LA
Posts: 27
Likes: 0
Received 0 Likes
on
0 Posts
jUST THAT QUICK!
I have a axial scx 10 . original axial 55 engine but a novak rooster ESC. Today I go to drive it and it is not driving at all. Jumping all over forward , reverse and the ikes. Is my ESC done and should I get a new one? Any input will be greatly appreciated.
#2
RE: jUST THAT QUICK!
try hooking the motor directly to the battery, and see if it spins fine. Could be your motor is going.
If it spins fine I would swap the channel one, and channel 2 to rule out the radio. if the servo works fine on channel 2 than its likely your ESC.
If it spins fine I would swap the channel one, and channel 2 to rule out the radio. if the servo works fine on channel 2 than its likely your ESC.
#4
Junior Member
Thread Starter
My Feedback: (3)
Join Date: May 2011
Location: baton Rouge,
LA
Posts: 27
Likes: 0
Received 0 Likes
on
0 Posts
RE: jUST THAT QUICK!
Thanks for all the help. Almost bought a Goat 21.5 to replace it and just when I go to try and start taking everything apart , I turned it on and it was fine . After a lil working on the throttle switch. Its back to crawling.