Turnigy TGY 9X and 9X8C radio system
10-11-2011, 07:27 AM
#1
Junior Member
Thread Starter
Join Date: Nov 2005
Location: Little River, SC
Posts: 4
Likes: 0
Received 0 Likes
on
0 Posts
Turnigy TGY 9X and 9X8C radio system
I have a Turnigy TGY 9X transmitter with a 9X8Cu2 receiver. This is a first time start up of this unit.(I also have a DX6 which works great). The problem I have with the Turnigy is that it will not bind the motor. It works all the servos perfectly but no matter what I do for the motor it does not bind. I have tried three different controllers, three different motors hooking them up in as many configurations as I can think of with no luck. The symptom shows itself by:
three musical beeps followed be three same tone beeps and then a continuous beeping.
Anybody got an idea how to get this transmitter and motor to talk to each other?
Jim
three musical beeps followed be three same tone beeps and then a continuous beeping.
Anybody got an idea how to get this transmitter and motor to talk to each other?
Jim
10-11-2011, 02:22 PM
#3
My Feedback: (21)
Join Date: Jul 2002
Location: Spencerport, NY
Posts: 7,350
Likes: 0
Received 0 Likes
on
0 Posts
RE: Turnigy TGY 9X and 9X8C radio system
1. Are you connecting the ESC to the throttle channel?
2. Have you tried to reverse the throttle channel? (IMPORTANT: remove the propeller first!)
2. Have you tried to reverse the throttle channel? (IMPORTANT: remove the propeller first!)
