*** BYRON T-28 build ***
#26
Thread Starter
My Feedback: (119)
Join Date: Feb 2002
Location: mcallen,
TX
Posts: 193
Likes: 0
Received 0 Likes
on
0 Posts
RE: *** BYRON T-28 build ***
making the speed brake holes, with this flat bit was very easy and they finish very sharp!
a little bit of resin on the back for the lose fibers and thats that
peter
a little bit of resin on the back for the lose fibers and thats that
peter
#31
Thread Starter
My Feedback: (119)
Join Date: Feb 2002
Location: mcallen,
TX
Posts: 193
Likes: 0
Received 0 Likes
on
0 Posts
RE: *** BYRON T-28 build ***
i put a little resin on the holes so the treads dot do a mess, also i install the bras hinges with cloth and resin and a few screws, later with the dremel i trim the fat parts on the insede so the door can seal very well
peter
#36
Thread Starter
My Feedback: (119)
Join Date: Feb 2002
Location: mcallen,
TX
Posts: 193
Likes: 0
Received 0 Likes
on
0 Posts
RE: *** BYRON T-28 build ***
just arrive the byron brakes, but i need to reinforce the center with JB WELD, because the last byron rims that i have, in the first landing the broke the internal axel
so i hope this ones last a little more
peter
#37
Thread Starter
My Feedback: (119)
Join Date: Feb 2002
Location: mcallen,
TX
Posts: 193
Likes: 0
Received 0 Likes
on
0 Posts
RE: *** BYRON T-28 build ***
PLEASE HELP!!, i have a BYRON air valve, but i dont have the manual or at least a diagram
anyone has a diagram of this valve??
thanks in advance
peter
[email protected]
#48
My Feedback: (53)
RE: *** BYRON T-28 build ***
ORIGINAL: peter b-RCU
PLEASE HELP!!, i have a BYRON air valve, but i dont have the manual or at least a diagram
anyone has a diagram of this valve??
thanks in advance
peter
[email protected]
PLEASE HELP!!, i have a BYRON air valve, but i dont have the manual or at least a diagram
anyone has a diagram of this valve??
thanks in advance
peter
[email protected]
A UP-3 is listed in the old catalog as the control valve for retracts and doors.
#49
My Feedback: (1)
RE: *** BYRON T-28 build ***
I would throw that away.....I did and replaced it with a U.P.1 valve. You can reach them at 905-842-1703 or Google them. United Precision products. They are in canada. The valve lets you time the speed of the retract as well as the doors. I have used their products for many years