steelerscotty

Hi I have a question for the rc pros out there.I have a chance to buy a couple of three blade props from a friend I know,but was wondering if they will work with my motors. they are 24x10's and I have a pair of planes with DLE 111 on them and when I looked up info on my motor it didn't say anything about swinging 24 inch props.This guy says he had them on a DA 100 and should be fine on my motors......is he right or not?

thanks guys I know you will have the right answer for me.
Scott

MetallicaJunkie

its on the small range... ive seen from 24x10 to 26x10 b blades.... 25x10 or is what most guys use for 3 blades..... i googled dle111 3blade http://bit.ly/xbhXZV

kmtranmd

My Feedback: (71)

24x10 3 blade is good for 80-85cc class. My 3W 80cc could swing Mej 24x10 at around 6800rpm. I imagine your DLE 111 will swing the snot out of this prop, unless your motor is old and tired.

steelerscotty

So are you saying its OK? or not.and the motors are only a year old so I hope they would work.
thanks for the reply too.

Scott

w8ye

My Feedback: (16)

They said the props were too small for a 111

steelerscotty

thank you I appreciate it the reply and your info!