thunder tiger e325
#1
Junior Member
Thread Starter
Join Date: Jun 2012
Location: winnsboro, SC
Posts: 3
Likes: 0
Received 0 Likes
on
0 Posts
thunder tiger e325
I am building a thunder tigermini titan . howeverthe tail pitch control lever does notmove very much if at all I have studied the manual and looked at several pictures of heli tails howeverI cannot get itto work. Any idea what I may be doinr wrong ? Thanks Tigerhawk
#2
Junior Member
Join Date: Dec 2005
Location: Calhoun,
LA
Posts: 21
Likes: 0
Received 0 Likes
on
0 Posts
RE: thunder tiger e325
Is it stiff or does it seem like it just won't move? You might try to oil it and free it up or take the tail shaft out and sand it down just a little.
#4
Junior Member
Join Date: Dec 2005
Location: Calhoun,
LA
Posts: 21
Likes: 0
Received 0 Likes
on
0 Posts
RE: thunder tiger e325
Ok I was thinking about the tail pitch slider. You are talking about the arm that the servo rod goes to. You should have a bushing and washer that goes in to keep it from binding when you tighten the screw that holds it in place. It sounds like it's binding against the bearing.