GP Spirit fin and rudder dimensions needed
#1
Thread Starter
Join Date: Aug 2007
Location: Perry, IA
Posts: 60
Likes: 0
Received 0 Likes
on
0 Posts
GP Spirit fin and rudder dimensions needed
I'm was recently given a partially built GP Spirit. The wing, fuse and horizontal stabilizer were built, but the vertical fin and rudder was not. My problem is that there were no plans in what was given to me.
I would like dimensions for the values in the attached photo. Thanks for your help in advance.
I would like dimensions for the values in the attached photo. Thanks for your help in advance.
#2
Senior Member
Join Date: May 2004
Location: Little Rock (via London Eng.),
AR
Posts: 206
Likes: 0
Received 0 Likes
on
0 Posts
RE: GP Spirit fin and rudder dimensions needed
Is this the Spirit Elite (2M), or the Spirit 100 (100ins). I only have the ARF versions, but others would need this info anyway. Good luck.
#4
Thread Starter
Join Date: Aug 2007
Location: Perry, IA
Posts: 60
Likes: 0
Received 0 Likes
on
0 Posts
RE: GP Spirit fin and rudder dimensions needed
I was able to come up with a fin and rudder design that will work. Thanks for at least reading the request for assistance.
Al
Al
#6
Thread Starter
Join Date: Aug 2007
Location: Perry, IA
Posts: 60
Likes: 0
Received 0 Likes
on
0 Posts
RE: GP Spirit fin and rudder dimensions needed
Antares100,
Thank you for the offer, but I have come up with dimensions and a design of my own. I read on a post somewhere that the Spirit needs more fin area to help stabilize it, so I guesstimated demensions from photos and then increased the fin area by about 20%
Thank you, Al
Thank you for the offer, but I have come up with dimensions and a design of my own. I read on a post somewhere that the Spirit needs more fin area to help stabilize it, so I guesstimated demensions from photos and then increased the fin area by about 20%
Thank you, Al