Blur engine madness
#1
Member
Thread Starter
Join Date: Dec 2005
Location: Deland,
FL
Posts: 30
Likes: 0
Received 0 Likes
on
0 Posts
Blur engine madness
The only way I can keep the enigne running is to set the high speed needle WAY rich, like 6 turns out. I can't find a low speed needle. It will run ok until the engine heats up, then it dies. I'm sure someone can tell me where the low speed needle is, and how to keep the engine running.
Thanks
Thanks
#4
Senior Member
Join Date: Oct 2006
Location: Sonoma,
CA
Posts: 1,289
Likes: 0
Received 0 Likes
on
0 Posts
RE: Blur engine madness
Rotary carb, not slide type.
I would guess the LSN is on the linkage side. The slotted screw in the middle.
http://www.shengines.com/spare%20par...ta/PT0701A.pdf
I would guess the LSN is on the linkage side. The slotted screw in the middle.
http://www.shengines.com/spare%20par...ta/PT0701A.pdf
#5
Member
Thread Starter
Join Date: Dec 2005
Location: Deland,
FL
Posts: 30
Likes: 0
Received 0 Likes
on
0 Posts
RE: Blur engine madness
Thanks guys, I found the low speed needle right where it should have been. It was so tight I thought it was only used th ehold on the throttle bracket. After setting it two turns out the motor ran a lot better, and after some tweaking to eliminate a little stall on tip in ran very well, right up to the point the pull start broke.